Sold out · Ask us about restocking
Not available to order right now.
The YIHUA 882D is a two-in-one rework station pairing a 60W soldering iron with a 750W hot air gun, aimed at electronics repair and rework where both fine soldering and component-level heat work are needed. A built-in PID program controls the temperature of both the soldering iron and the hot air gun independently, holding each within roughly 1C of the set point rather than letting it drift up and down.
The hot air side covers a 100C to 480C range, which spans everything from gentle preheating to the higher temperatures needed for SMD rework and desoldering, with adjustable airflow up to 120L/min so the intensity can be turned down for delicate work or up for stubborn joints.
The soldering iron side runs from 200C to 480C, using a ceramic heating element, which heats quickly and holds its temperature more consistently than older resistance-wire designs. Both the iron and the hot air gun run on 220-240V AC at 50 or 60Hz, so the unit is built around that mains voltage range.
Having both tools built into one station saves bench space compared to running separate soldering and hot air equipment, and the shared PID-controlled electronics mean both sides benefit from the same temperature stability.
Technicians and hobbyists doing SMD rework, component replacement or general circuit board repair will get the most from having both a stable soldering iron and a controllable hot air gun on one bench, rather than juggling separate single-purpose tools.
100C to 480C.
A 60W ceramic-element iron running from 200C to 480C.
Yes, on both the soldering iron and the hot air gun independently.
Adjustable airflow up to 120L/min.
220-240V AC at 50 or 60Hz.
| Brand | YIHUA |
|---|---|
| Power | 60W (iron) / 750W (hot air) |
| Selling unit | PCS |
