1 / 4Standard checkout available. Verified maker dispatch.
This 20cm XT60 multi-adapter cable is built for charging flexibility. It has a robust XT60 input that branches into XT60, XT30, JST, DC5.5 and T-plug outputs.
The thick wiring keeps power loss low and efficiency high, which makes it suitable for RC enthusiasts, drone users and DIY electronics projects. It lets you connect different battery types and charging devices with a single power distribution lead.
The listing gives a wire length of 20cm and a rated temperature range of -60 to +200 degrees C.
XT60 input: a robust high-current input connector.
Five output connectors: XT60, XT30, JST, DC5.5 (2.1 goggle plug) and T-plug.
Thick low-loss wire: helps keep power loss minimal.
Wide temperature rating: -60 to +200 C.
Flexible charging: one cable for many batteries and devices.
A power connector is the link between your battery and everything that draws current from it. It has to hold securely, carry the current without heating up and, ideally, only fit together one way so that reverse polarity is impossible. The metal contacts are usually gold plated to resist corrosion, and the housing holds the two contacts apart and keeps them aligned.
Solder connectors with a clean, hot joint and enough solder to fill the cup, then slide heat-shrink over the joint so no bare metal is exposed. A cold or under-heated joint has high resistance and gets hot under load, which is the most common cause of connector failure. Always check polarity before you plug in a battery for the first time.
Choose connectors by the current they will actually carry, not just by how they look. A connector that is too small runs hot and can melt its housing, while a connector that is rated well above your load stays cool and lasts longer. Inspect connectors periodically, and replace any that show discolouration, loose contacts or cracked housings.
Connecting different battery types to one charger
Powering FPV goggles through a DC5.5 plug
Adapting XT60 chargers to XT30, JST or T-plug batteries
Workshop and field charging kits
DIY electronics power distribution
The title and description state 16AWG wire while the specification table lists 18AWG. Because the listing is not consistent, treat the cable as a light-duty adapter and check current needs before using it near the limits of a heavy pack.
The listing notes that the smaller XT30 is used for lower current applications, so respect the lowest current rating among the connectors you actually use.
Item type: cable, plug
Model type: T plug, XT30, XT60
Output connectors: XT60 / T / XT30 / JST / DC5.5 2.1 goggle plug
Wire length: 20cm
Wire gauge: 16AWG in the title, 18AWG in the spec table
Rated temperature: -60 to +200 C
1 x XT60 to XT60 / XT30 / JST / DC5.5 / T-plug adapter
RC and drone pilots who need a single adapter cable for charging or powering gear from different connector styles.
XT60.
XT60, XT30, JST, DC5.5 and T-plug.
20cm.
-60 to +200 C.
The title says 16AWG; the specification table lists 18AWG.
One XT60 multi-plug adapter.
| Brand | Generic |
|---|---|
| Cable Length | 20 cm cm |
| Connector | XT60 to XT60/XT30/JST/DC5.5/T-plug |
| Operating Temperature | -60 to 200 C |
| Selling unit | PCS |
