1 / 4Sold out · Ask us about restocking
Not available to order right now.
The T-Motor Flame 60A HV is a brushless ESC for multirotor applications. The page describes a special core program for improved throttle response and smooth motor control, and optimised software for disc-type motors.
The core specifications give a rated speed of 210,000 RPM, a maximum output current of 60A, a 5V voltage regulator and battery support of 6-12S LiPo. It supports signal frequencies up to 600 Hz and comes with a 1-year manufacturer warranty for manufacturing defects. The page showed only 5 left at Rs 7,969 (SKU TIFQC0205).
60A maximum output current: for 6-12S LiPo.
Special core program: improved throttle response and smooth motor control.
Optimised for disc-type motors: as listed.
Signal frequencies up to 600 Hz: as listed.
5V voltage regulator: as listed.
Intelligent adaptive design: with preset settings.
An electronic speed controller (ESC) converts the throttle signal from the flight controller into the three-phase power that a brushless motor needs. It switches battery current through MOSFETs at high speed, so the motor turns at the speed that the pilot or autopilot asks for. The continuous current rating shows how much current the ESC can carry all the time, and the burst rating shows what it can survive for a few seconds.
Match the ESC to the rest of the power system. The battery cell count must fall inside the listed range, the continuous current must be higher than what your motor and propeller draw at full throttle, and the signal protocol (for example PWM, Oneshot, Multishot or DShot) must be supported by your flight controller. An ESC marked OPTO has no built-in BEC, so the receiver and flight controller need power from another source. An ESC with a BEC can supply a regulated voltage, usually 5V, to small electronics.
Install and test carefully. Solder joints must be clean and strong, the motor wires should be kept short and tidy, and the ESC needs airflow because current makes heat. Calibrate the throttle range if the ESC needs it, check the motor direction with the propellers removed, and never connect a battery with the propellers fitted while you are working on the wiring. Use a battery with a cell count and connector that suit the ESC, and check for a heat problem after a short test hover.
Large multirotors
High-voltage 6-12S power systems
Disc-type motor setups
UAV platforms
Photography drones
The ESC is for 6-12S LiPo only, so do not use it on smaller packs. It has an intelligent adaptive design with preset settings.
The page does not give dimensions or weight.
Item type: brushless ESC
Rated speed: 210,000 RPM
Max output current: 60A
Voltage regulator: 5V
Battery support: 6-12S LiPo
Signal frequency: up to 600 Hz
Warranty: 1 year (defects only)
1 x T Motor Flame 60A HV brushless ESC
Builders of high-voltage multirotors who need a 60A ESC.
6-12S LiPo.
60A.
Up to 600 Hz.
A 1-year manufacturer warranty for defects.
| Brand | T-Motor |
|---|---|
| Battery Support | 6S-12S |
| Continuous Current | 60.000000 A |
| Optimum RPM | 210000 |
| Selling unit | PCS |
