1 / 3Sold out · Ask us about restocking
Not available to order right now.
The SimpliFly ESC 30A is described as a reliable and efficient ESC for BLDC motors, designed to deliver precise speed control and consistent power output for drone applications. It supports 2S to 6S LiPo batteries and uses D-Shot and OneShot125 protocols.
The specification table gives 30A constant, 40A burst, a BLHeli 32 firmware base, D-Shot up to 1200 and OneShot125, and a black colour. The page prints dimensions of 6.5 mm x 2.5 mm x 7.0 mm and a weight of 0.027 g, which are clearly wrong, so ignore them. The package is one ESC and a user manual. At the time of the check the page showed it as sold out at Rs 862 (SKU TIFQC0197).
30A constant, 40A burst: for stable power delivery.
2S to 6S LiPo: a wide range of drone builds.
D-Shot and OneShot125: fast and precise throttle response.
BLHeli 32 base: as listed.
Programmable motor direction and throttle range: as listed.
Low-voltage cut-off and overheat protection: as listed.
An electronic speed controller (ESC) converts the throttle signal from the flight controller into the three-phase power that a brushless motor needs. It switches battery current through MOSFETs at high speed, so the motor turns at the speed that the pilot or autopilot asks for. The continuous current rating shows how much current the ESC can carry all the time, and the burst rating shows what it can survive for a few seconds.
Match the ESC to the rest of the power system. The battery cell count must fall inside the listed range, the continuous current must be higher than what your motor and propeller draw at full throttle, and the signal protocol (for example PWM, Oneshot, Multishot or DShot) must be supported by your flight controller. An ESC marked OPTO has no built-in BEC, so the receiver and flight controller need power from another source. An ESC with a BEC can supply a regulated voltage, usually 5V, to small electronics.
Install and test carefully. Solder joints must be clean and strong, the motor wires should be kept short and tidy, and the ESC needs airflow because current makes heat. Calibrate the throttle range if the ESC needs it, check the motor direction with the propellers removed, and never connect a battery with the propellers fitted while you are working on the wiring. Use a battery with a cell count and connector that suit the ESC, and check for a heat problem after a short test hover.
Multirotors
Fixed-wing aircraft
Helicopters
2S-6S builds
BLHeli_32 setups
The ESC has programmable motor direction and an adjustable throttle range, plus low-voltage cut-off and overheat protection.
The dimension and weight lines on the page look garbled, so measure the real unit before you plan a tight install.
Constant current: 30A
Burst current: 40A
Battery support: 2S to 6S LiPo
Firmware: D-Shot (up to 1200), OneShot125
Firmware base: BLHeli 32
Colour: black
1 x SimpliFly ESC 30A (2S-6S)
Multirotor builders who want a BLHeli_32 30A ESC.
30A constant and 40A burst.
2S to 6S LiPo.
BLHeli 32.
The ESC and a user manual.
| Brand | SimpliFly |
|---|---|
| Battery Support | 2S-6S |
| Burst Current | 40.000000 A |
| Continuous Current | 30.000000 A |
| Firmware | BLHeli_32 |
| Protocol | DShot up to 1200, OneShot125 |
| Selling unit | PCS |
