1 / 3Sold out · Ask us about restocking
Not available to order right now.
The MinimOSD is a companion on-screen display (OSD) board. It interprets the MAVLink telemetry data from your flight controller and displays it as an overlay on the video feed, so you get your flight information directly on screen when flying FPV.
Pilots can see their flight data through the goggles or monitor without relying on a laptop for telemetry monitoring.
The board combines an ATmega328 microcontroller with the MAX7456 OSD chip, and it operates from a 5V to 12V DC supply with an onboard regulator.
ATmega328 and MAX7456: a proven combination for OSD boards.
MAVLink support: reads the telemetry protocol used by APM and Pixhawk.
APM compatible: works with APM 2.6 and APM 2.52 boards.
5V to 12V DC input: includes a +5V 500mA regulator for up to +12V supply.
6-pin ISP header: standard header for programming.
An OSD board sits between your FPV camera and your video transmitter. It reads the MAVLink telemetry stream from the flight controller and draws the values as text on the video signal, so what you see in goggles or on a monitor includes flight data.
Because the data is added to the video itself, no extra screen or radio link is needed at the flying site.
Most pilots configure which values appear and where they sit on the screen using the ground-station software before flying. Keep the on-screen layout simple, with battery voltage, altitude and flight mode in easy view, so that the overlay helps rather than clutters your view of the flight.
FPV flights with APM 2.6 or APM 2.52
Pixhawk and PIX controllers
Reading telemetry through goggles
Custom OSD configuration via the ISP header
Field flying without a laptop
Compatible boards: APM 2.6, APM 2.52, PIX and Pixhawk. The board uses MAVLink, so the flight controller must output MAVLink telemetry.
The package includes a jumper wire. Because the board is programmed through the 6-pin ISP header, you can flash and configure the OSD firmware and its character set with the usual MinimOSD tools before installing it in the aircraft, then wire it between the camera and the video transmitter.
OSD chip: MAX7456
Microcontroller: ATmega328
Protocol: MAVLink
Input voltage: 5V-12V DC
Pins: 6
Material: plastic/metal
1 x Mini OSD module
1 x jumper wire
APM 2.6 / APM 2.52 users who fly FPV and want telemetry overlaid on their video feed.
ATmega328 and MAX7456.
5V to 12V DC.
MAVLink.
APM 2.6, APM 2.52, PIX and Pixhawk.
Yes, a standard 6-pin ISP header.
The Mini OSD module and a jumper wire.
| Brand | Generic |
|---|---|
| Compatible Flight Controllers | APM 2.6, APM 2.52, PIX, Pixhawk |
| Input Voltage | 5V-12V DC |
| MCU / Processor | ATmega328 |
| OSD Chip | MAX7456 |
| Protocol | MAVLink |
| Selling unit | PCS |
