1 / 2Standard checkout available. Verified maker dispatch.
The iFlight Nazgul5 V3 is a durable and lightweight freestyle frame designed for FPV drone flying. The page describes carbon fiber construction, crash resistance and easy component installation, with a spacious interior for electronics.
The technical specifications give a 245 mm wheelbase, frame dimensions of L173 x W173 x H36.5 mm, a 5 mm arm thickness, a 3 mm bottom plate, a 2.5 mm top plate, 16x16 mm motor mounting and a weight of 130 g without TPU parts. The page did not show the item as out of stock at ₹5,619.
Durable carbon fiber: high strength.
5 inch propellers: fits perfectly.
245 mm wheelbase: 173 x 173 x 36.5 mm.
5 mm arms, 3 mm bottom plate: as listed.
Vibration-damped camera mount: included.
130 g: without TPU parts.
A drone frame is the skeleton that holds everything together: the arms carry the motors, the plates carry the flight controller, ESCs, battery and camera, and the whole structure must be stiff enough that vibration does not reach the gyro. Carbon fibre is the standard material because it is light and very rigid. The wheelbase, measured motor to motor across the diagonal, sets the size of propeller the frame can carry, and the arm thickness sets how well it survives crashes.
Match the frame to your parts. Check the motor mounting pattern, the flight controller and ESC stack hole spacing, the camera width, the video system you want to fly and the largest propeller the arms allow. TPU parts such as arm guards, antenna mounts and camera mounts are printed in a flexible plastic so they absorb impact. The battery strap and anti-slip pad keep the pack from moving under G-force.
Build carefully. Use thread-locking compound on the metal screws that are not in a plastic nut, keep the screw lengths from the hardware bag matched to the holes they belong in, and do not over-tighten screws into carbon fibre. Route motor wires away from sharp plate edges, mount the flight controller on soft grommets when the frame supports it, and check that nothing rubs a propeller before the first flight. After a crash, inspect the arms for cracks and replace any that are damaged.
Plan the balance of the build. A heavier battery moves the centre of gravity, so place it where the frame is designed to carry it, and keep the antenna, GPS and camera clear of the carbon plates where possible because carbon blocks radio signals.
5 inch freestyle
Cinematic FPV
Nazgul builds
Crash-prone flying
General FPV builds
The motor mounting is 16x16 mm. The kit includes a GoPro TPU base mount, four TPU arm guards, bottom-plate front and rear protection, four motor wire shield tubes and two 20x250 mm battery straps.
The page describes a vibration-damped camera mount.
Wheelbase: 245 mm
Frame dimensions: L173 x W173 x H36.5 mm
Arm thickness: 5 mm
Bottom plate: 3 mm
Top plate: 2.5 mm
Motor mounting: 16x16 mm
Weight: 130 g (without TPU parts)
1 x Nazgul5 V3 frame kit
1 x GoPro TPU base mount
1 x Screw bag
4 x TPU armguard
1 x Bottom plate front protection TPU
1 x Bottom plate rear protection TPU
1 x Anti-slip battery pad
4 x Motor wire shield tube
2 x Battery strap (20x250 mm)
Freestyle pilots who want a proven 5 inch frame.
245 mm.
130 g without TPU parts.
5 mm.
16x16 mm.
| Brand | iFlight |
|---|---|
| Arm Thickness | 5.000000 mm |
| Material | Carbon fiber |
| Weight | 130.000000 g |
| Wheelbase | 245.000000 mm |
| Selling unit | PCS |
