Holybro Power Distribution Board, Pre-Soldered XT60/XT30, 60A

This Holybro power distribution board is built specifically to pair with Holybro's PM02 and PM02D power modules, giving a complete, matched power path from the battery through to the ESCs on a build like the X500 V2 platform. XT60 connectors come pre-soldered for both the power module connection and the main battery input, saving a soldering step that many bare PDBs still leave to the builder, and optional pre-soldered XT30 connectors are available for the ESC and motor connections as well.

Current handling is rated at 60A continuous, with a 120A maximum sustained for under 60 seconds, giving genuine headroom for mid-size multirotor builds that draw real current under load, well beyond the capacity of a typical small racing-quad PDB. Mounting uses a 45x45mm hole pattern, a size that matches many standard flight controller and power module mounting footprints in the Pixhawk-compatible ecosystem.

Holybro's own documentation notes that the included wiring diagram is for reference only, so builders should confirm the exact pinout and connection order against their specific power module and flight controller combination before wiring, rather than assuming the reference diagram applies universally across every possible Pixhawk-family setup.

The board is aimed at mid-size multirotor platforms like the Holybro X500 V2 and similar builds using a PM02 or PM02D power module, where a mismatched PDB current rating or connector choice is an easy mistake to make when mixing components from different sources. Builders standardizing on Holybro's PM02-family power modules will find this board's pre-soldered connectors and matched current rating remove that compatibility guesswork entirely.