1 / 2Standard checkout available. Verified maker dispatch.
This ESC power distribution board simplifies multirotor builds by sharing battery power between the ESCs. It comes with soldered 3.5mm banana bullet connectors and an XT60 plug for easy connection to your ESCs and battery.
The listing says the pre-soldered connectors save time and effort during assembly, and that the board suits many multirotor models, including QAV250, 280 and F450 quadcopters.
It gives efficient power distribution, keeps wiring clean and organised and is made from high-quality materials for lasting reliability.
Soldered connections: pre-soldered banana bullet connectors and XT60 plug save time.
Versatile compatibility: QAV250, 280 and F450 quadcopters.
Efficient power distribution: a clean, organised setup.
Durable construction: high-quality materials for reliability.
Warranty: 14-day replacement warranty for manufacturing defects.
A power distribution board (PDB) takes the current from the flight battery and shares it between the ESCs and other parts of the aircraft. Instead of soldering every ESC lead to a single battery lead, you solder them to wide copper pads on the board, which handles the current safely and keeps the wiring tidy. Many boards also include voltage regulators, so that a flight controller, receiver or camera can be powered from the same board.
When you choose a PDB, check that its current rating comfortably exceeds the total of all your ESCs at full throttle, that its input voltage range covers your battery and that the pad spacing and connectors match your frame and wire gauge. Solder with a hot iron and plenty of flux so that each joint flows, and cover joints with heat-shrink.
Check every joint for cold solder and shorts before you connect a battery, and use a smoke stopper for the first power-up. A small hairline crack in a solder joint can heat up under load and fail, so re-inspect the board after crashes.
QAV250, 280 and F450 multirotor builds
Plug-in ESC connections with banana bullets
XT60 battery connection
Replacing a damaged PDB
Tidy wiring on small frames
The specification list gives the brand as ReadytoSky and the part number as PDB-001. The page does not give a current rating, dimensions or the number of ESC outputs, so check the seller before designing a high-current build around it.
The listing states a 14-day replacement warranty for manufacturing defects. The package contents are not listed.
Brand: ReadytoSky
MPN: PDB-001
Battery connector: XT60 plug (soldered)
ESC connectors: 3.5mm banana bullet connectors (soldered)
Fits: QAV250, 280, F450
Warranty: 14-day replacement for manufacturing defects
1 x ESC power distribution board with XT60 plug and 3.5mm banana bullet connectors
Builders of QAV250, 280 and F450 multirotors who want a PDB with connectors already fitted.
QAV250, 280 and F450 quadcopters.
An XT60 plug and 3.5mm banana bullet connectors.
No, they are pre-soldered.
ReadytoSky (PDB-001).
A 14-day replacement warranty for manufacturing defects.
The page does not state it.
| Brand | ReadytoSky |
|---|---|
| Compatible Drone | QAV250, 280, F450 |
| Connector | XT60 plug, 3.5mm banana bullets |
| Selling unit | PCS |
