1 / 2Sold out · Ask us about restocking
Not available to order right now.
The Emax Simon K Series 60A is a high-performance ESC designed specifically for drones and multirotor aircraft. The page says it is built on SimonK firmware for ultra-fast throttle response and stable power output.
It gives 60A constant and 80A burst current (10 seconds), a 5V/5A BEC, 2S to 6S LiPo compatibility, low-voltage and overheat protection, fully programmable parameters and high-quality MOSFETs. It is black. The page showed the item in stock at Rs 1,774.
60A continuous, 80A burst: burst for 10 seconds.
Built-in 5V/5A UBEC: for onboard electronics.
SimonK firmware: ultra-fast throttle response.
2S to 6S LiPo: as listed.
Low-voltage and overheat protection: as listed.
Fully programmable parameters: as listed.
An electronic speed controller (ESC) converts the throttle signal from the flight controller into the three-phase power that a brushless motor needs. It switches battery current through MOSFETs at high speed, so the motor turns at the speed that the pilot or autopilot asks for. The continuous current rating shows how much current the ESC can carry all the time, and the burst rating shows what it can survive for a few seconds.
Match the ESC to the rest of the power system. The battery cell count must fall inside the listed range, the continuous current must be higher than what your motor and propeller draw at full throttle, and the signal protocol (for example PWM, Oneshot, Multishot or DShot) must be supported by your flight controller. An ESC marked OPTO has no built-in BEC, so the receiver and flight controller need power from another source. An ESC with a BEC can supply a regulated voltage, usually 5V, to small electronics.
Install and test carefully. Solder joints must be clean and strong, the motor wires should be kept short and tidy, and the ESC needs airflow because current makes heat. Calibrate the throttle range if the ESC needs it, check the motor direction with the propellers removed, and never connect a battery with the propellers fitted while you are working on the wiring. Use a battery with a cell count and connector that suit the ESC, and check for a heat problem after a short test hover.
Multirotors
Heavy drones
2S-6S builds
Builds needing a strong BEC
SimonK setups
The BEC gives 5V at 5A, which can support onboard electronics. It is programmable and protects against low voltage and overheating.
The page gives no dimensions or weight, so measure your frame before you buy.
Item type: brushless ESC
Model: Emax Simon K Series 60A ESC
Constant current: 60A
Burst current: 80A (10 s)
BEC: 5V/5A
LiPo: 2S to 6S
Colour: black
1 x Emax Simon K Series 60A brushless ESC
Multirotor builders who need a 60A ESC with a 5A BEC.
60A constant and 80A burst for 10 s.
5V/5A.
2S to 6S LiPo.
SimonK.
| Brand | EMAX |
|---|---|
| Continuous Current | 60.000000 A |
| Selling unit | PCS |
