1 / 2Standard checkout available. Verified maker dispatch.
The AxisFlying Manta 6 is a robust 6-inch FPV freestyle Deadcat DC type frame kit designed for stability and manoeuvrability. The page describes a K-shaped structure so the propellers are not seen in flight, which gives a wider field of vision.
The technical specifications give a 265 mm wheelbase, a bottom plate of 3 mm or 2.5 mm, T700 carbon material, a 25 mm bottom-to-top distance, 5 mm arm width (with a 6 mm thick quick-release design), lens space of 14 to 20 mm, 16x16 mm motor mounting, a maximum prop size of 6.1 inches and a weight of 301 ± 5 g. The page did not show the item as out of stock at ₹5,859.
K-shaped structure: propellers cannot be seen in flight.
6 mm thick quick-release design: as listed.
Bottom LED and beeper: for night flying.
GPS above the antenna: for less interference.
Double strap ties: for secure battery installation.
T700 carbon: 265 mm wheelbase.
A drone frame is the skeleton that holds everything together: the arms carry the motors, the plates carry the flight controller, ESCs, battery and camera, and the whole structure must be stiff enough that vibration does not reach the gyro. Carbon fibre is the standard material because it is light and very rigid. The wheelbase, measured motor to motor across the diagonal, sets the size of propeller the frame can carry, and the arm thickness sets how well it survives crashes.
Match the frame to your parts. Check the motor mounting pattern, the flight controller and ESC stack hole spacing, the camera width, the video system you want to fly and the largest propeller the arms allow. TPU parts such as arm guards, antenna mounts and camera mounts are printed in a flexible plastic so they absorb impact. The battery strap and anti-slip pad keep the pack from moving under G-force.
Build carefully. Use thread-locking compound on the metal screws that are not in a plastic nut, keep the screw lengths from the hardware bag matched to the holes they belong in, and do not over-tighten screws into carbon fibre. Route motor wires away from sharp plate edges, mount the flight controller on soft grommets when the frame supports it, and check that nothing rubs a propeller before the first flight. After a crash, inspect the arms for cracks and replace any that are damaged.
Plan the balance of the build. A heavier battery moves the centre of gravity, so place it where the frame is designed to carry it, and keep the antenna, GPS and camera clear of the carbon plates where possible because carbon blocks radio signals.
6 inch freestyle
Deadcat builds
Night flying
GPS builds
Wide-view flying
The frame supports lens space of 14 to 20 mm and props up to 6.1 inches. The GPS mounts above the antenna to reduce interference.
The page prints both 6 mm and 5 mm for the arms, so measure them on arrival.
Wheelbase: 265 mm
Bottom plate thickness: 3 mm / 2.5 mm
Carbon material: T700
Bottom-to-top distance: 25 mm
Arm width: 5 mm
Lens space: 14-20 mm
Motor mounting: 16x16 mm
Max propeller size: 6.1 inch
Weight: 301 ± 5 g
1 x AXISFLYING MANTA6 6 inch FPV freestyle Deadcat DC type frame kit
Freestyle pilots who want a 6 inch Deadcat frame with a bottom LED.
265 mm.
6.1 inches.
301 ± 5 g.
Yes, a bottom LED and beeper for night flying.
| Brand | AxisFlying |
|---|---|
| Wheelbase | 265.000000 mm |
| Selling unit | PCS |
