1 / 3Sold out · Ask us about restocking
Not available to order right now.
This listing packs a 35A ESC and a 45A ESC for FPV quadcopters with an integrated RGB LED. The page describes the 35A ESC as designed for high-performance applications in 2-6S LiPo systems and the 45A ESC as designed for demanding use in small to medium RC aircraft.
The specification list gives 2-6S power, 35A continuous with a 45A peak for 10 seconds and 45A continuous with a 55A peak for 10 seconds, DShot125/300/600 and Oneshot125, a weight of 6 g, a size of 13 x 28.5, an 18AWG 90 mm power cord and a 150 mm signal line. The page showed it in stock at Rs 2,692.
35A: 35A continuous, 45A peak (10 s): one ESC in the pack.
45A: 45A continuous, 55A peak (10 s): the second ESC in the pack.
2-6S power supply: as listed.
DShot125/300/600 and Oneshot125: supported protocols.
Integrated RGB LED: as named in the title.
6 g, 13 x 28.5: weight and size.
An electronic speed controller (ESC) converts the throttle signal from the flight controller into the three-phase power that a brushless motor needs. It switches battery current through MOSFETs at high speed, so the motor turns at the speed that the pilot or autopilot asks for. The continuous current rating shows how much current the ESC can carry all the time, and the burst rating shows what it can survive for a few seconds.
Match the ESC to the rest of the power system. The battery cell count must fall inside the listed range, the continuous current must be higher than what your motor and propeller draw at full throttle, and the signal protocol (for example PWM, Oneshot, Multishot or DShot) must be supported by your flight controller. An ESC marked OPTO has no built-in BEC, so the receiver and flight controller need power from another source. An ESC with a BEC can supply a regulated voltage, usually 5V, to small electronics.
Install and test carefully. Solder joints must be clean and strong, the motor wires should be kept short and tidy, and the ESC needs airflow because current makes heat. Calibrate the throttle range if the ESC needs it, check the motor direction with the propellers removed, and never connect a battery with the propellers fitted while you are working on the wiring. Use a battery with a cell count and connector that suit the ESC, and check for a heat problem after a short test hover.
FPV quadcopters
Small and medium RC aircraft
2-6S builds
Mixed-current builds
LED-lit builds
The package holds one 35A and one 45A ESC, so check which rating suits each motor before you install them.
The size is printed as 13*28.5 without units.
Voltage: 2-6S
35A: continuous 35A, peak 45A (10 s)
45A: continuous 45A, peak 55A (10 s)
Protocols: DShot125/300/600, Oneshot125
Weight: 6 g
Size: 13 x 28.5
Power cord: 18AWG 90 mm
Signal line: 150 mm
1 x 35A ESC and 45A ESC (brushless)
Builders who want one 35A and one 45A ESC for 2-6S quads.
One 35A and one 45A brushless ESC.
2-6S.
DShot125/300/600 and Oneshot125.
6 g.
| Brand | Generic |
|---|---|
| Supported Protocols | DShot125/300/600, Oneshot125 |
| Weight | 6.000000 g |
| Selling unit | PCS |
