15cm Pre-Crimped Cables (6 Colors) with SH1.0 Connectors

15cm Pre-Crimped Cables (6 Colors) with SH1.0 Connectors

These 15cm pre-crimped cables with SH1.0 connectors come in six colours and are made for FPV flight controllers. The listing says they are compatible with SPRacingF3, OMNIBUS F4 Pro and F7 flight controllers.

They enable easy DIY cable customisation: the SH1.0 connectors are already crimped, so you can build the lead you need without a crimping tool.

They support connections to a camera, VTX, GPS, telemetry, OSD, Bluetooth and ultrasonic sensors, and the ultra-soft silicone wires stay flexible even in cold conditions.

Key features

• Popular controller compatibility: SPRacingF3, OMNIBUS F4 Pro and F7.

• SH1.0 connectors: for easy DIY cable customisation.

• Many peripherals: camera, VTX, GPS, telemetry, OSD, Bluetooth and ultrasonic sensors.

• Ultra-soft silicone wires: great flexibility, even in cold conditions.

• Six colours: colour coding makes wiring easier to follow.

How pre-crimped cables help

Flight controllers use small board-to-board connectors so that a camera, VTX, GPS or receiver can be plugged in without soldering. A pre-crimped cable has the connector already attached at one end, so you only need to solder or connect the other end to the device.

Soft silicone wire is easy to route in tight frames and does not stiffen, which is helpful for cold-weather flying and for reducing strain on small connectors.

Colour coding helps you keep track of signal, power and ground lines, which reduces wiring mistakes.

When you build a lead, double-check the pin order at both ends against the manuals of the flight controller and the peripheral, because an incorrectly wired cable can damage electronics. Test with a multimeter before powering up, and secure the finished cable with a tie or a dab of adhesive so that vibration does not pull on the connector.