1 / 2Standard checkout available. Verified maker dispatch.
This is a 1045 carbon fibre propeller pair in orange, with one clockwise and one anticlockwise prop. The page describes it for DIY multicopters, with quick-to-release and quick-to-attach abilities and high endurance.
The specification list gives a 10 inch length, 4.5 inch pitch, 7.7 mm shaft diameter and 25 g weight. The listed compatible motors are the A2212 in 1000KV, 1400KV, 1800KV and 2200KV with a 30A ESC. The page showed only 4 left in stock at Rs 77 (SKU TIFQC0004).
Carbon fibre material: light in weight at 25 g.
1045 size: 10 inch length and 4.5 inch pitch.
15 degree propeller angle: to avoid whirlpool while flying.
7.7 mm shaft diameter: as listed.
Quick release and attach: as described.
Hole set included: with the CW and CCW props.
A drone propeller converts motor torque into thrust. Each blade is an aerofoil: as the motor spins the prop, the blades push air downward and the reaction force lifts the aircraft. Diameter and pitch set how the prop behaves. A larger diameter moves more air and suits efficient, lower-RPM flight, while a higher pitch moves the aircraft forward faster per revolution but demands more current from the motor.
Multirotors use pairs of props that spin in opposite directions. Clockwise (CW) and counter-clockwise (CCW) props cancel out the torque reaction so the aircraft does not spin, and the flight controller changes individual motor speeds to steer. Always fit each prop on the motor that turns the matching direction, and check your flight controller motor-direction settings before the first flight.
Fit and balance matter. The hub hole or shaft size must match your motor shaft, and the prop should sit flat and tight with the retaining nut fully secured. Check every blade for chips, cracks and bends before each flight, because a damaged prop causes vibration that shows up as jello in the video and extra heat in the motor. Replace props after a hard crash instead of flying on a damaged set.
Keep a few spare sets in your kit. Props are the part most likely to break in a crash, and swapping a damaged one takes only a minute. When you replace a prop, replace it with the same size, pitch and blade count as the rest of the set so that all motors produce matching thrust.
DJI F450-class quadcopters
DIY multicopters
A2212 motor builds
Replacement props
Hobby projects
The listed compatible motors are A2212 1000KV, 1400KV, 1800KV and 2200KV with a 30A ESC. The shaft diameter is 7.7 mm.
The pack includes one hole set with the props. Fit CW and CCW props to the matching motors.
Material: carbon fibre
Length: 10 inch
Pitch: 4.5 inch
Shaft diameter: 7.7 mm
Color: Orange
Weight: 25 g
Propeller type: 1045
Compatible motors: A2212 1000KV, 1400KV, 1800KV, 2200KV with 30A ESC
1 x 1045 propeller (clockwise)
1 x 1045 propeller (anticlockwise)
1 x Hole set
DIY multicopter builders who need a 10 inch carbon fibre pair.
10 x 4.5 inches.
7.7 mm.
25 g.
A2212 1000KV, 1400KV, 1800KV and 2200KV motors with a 30A ESC.
| Brand | Generic |
|---|---|
| Diameter | 10.000000 in |
| Material | carbon fibre |
| Pitch | 4.500000 in |
| Propeller Angle | 15.000000 deg |
| Shaft Diameter | 7.700000 mm |
| Weight | 25.000000 g |
| Selling unit | PCS |